The point group affects the free energy
The use of point group symmetry in quantum chemical calculations can speed up calculations significantly, but it is often difficult to input symmetric coordinates correctly so many people opt to run calculations without symmetry (i.e. in $C_1$ symmetry) anyway. However, the lack of symmetry changes the rotational entropy and, hence, the free energy you compute. So if you have symmetric molecules but choose to run in $C_1$ symmetry you must correct the entropies and free energies.
The rotational entropy is given by$$S_{rot}=R\ln\left(\frac{8\pi^2}{\sigma}\left(\frac{2\pi ekT}{h^2}\right)^{3/2}\sqrt{I_1I_2I_3}\right)$$ $\sigma$ is called the symmetry number and depends on the point group: for example, $\sigma=1$ for $C_1$ and $C_s$, $\sigma=n$ for $C_{nv}$ and $C_{nh}$, $\sigma= 2n$ for $D_{nh}$ and $D_{nd}$, and $\sigma= 12$ or $T_d$. So the rotational entropy calculated with and without symmetry will differ by $R\ln(\sigma)$:$$S_{rot}=S_{rot}^{C_1}R\ln(\sigma)$$and similarly for the free energy$$G^\circ=G^{\circ,C_1}+RT\ln(\sigma)$$ An example: $H_2O+Cl^\rightleftharpoons HOH\cdots Cl^$
The free energy change for this reaction is$$\Delta G^\circ=\Delta G^{\circ,C_1}+RT\ln\left(\frac{\sigma_{HOH\cdots Cl^(C_s)}}{\sigma_{H_2O(C_{2v})}\sigma_{Cl^(C_1)}}\right)\\ \Delta G^\circ=\Delta G^{\circ,C_1}+RT\ln\left(\frac{1}{2\times 1}\right)=\Delta G^{\circ,C_1}RT\ln (2)$$The corresponding equilibrium constants are$$K=e^{\Delta G^\circ/RT}=2K^{C_1}$$So, $\sigma$'s accounts for the fact that, because of the symmetry of water, there are two ways of making $HOH\cdots Cl^$and another way to view $R\ln(2)$ is that it is the conformational entropy of the complex.
A test: $H_2O+NH_3\rightleftharpoons HOH\cdots NH_3$
For the above equilibrium what is $X$ in$$\Delta G^\circ=\Delta G^{\circ,C_1}RT\ln (X)$$
An exception: $2H_2O\rightleftharpoons HOH\cdots OH_2$
Based on the rules outlined so far one would expect the free energy change for this equilibrium to be$$\Delta G^\circ=\Delta G^{\circ,C_1}RT\ln (4)$$The factor of four accounts for the fact that there are four ways of making $HO^AH\cdots O^BH_2$. However, since the water molecules are identical there are actually four additional water dimer possibilities for $HO^BH\cdots O^AH_2$, so$$\Delta G^\circ=\Delta G^{\circ,C_1}RT\ln (8)$$In general, for $A+A\rightleftharpoons Product$ reactions the symmetry number for $A+A$ is $2\sigma_A^2$rather than $\sigma_A^2$
All these considerations also apply to activation free energies and rate constants as outlined in this excellent paper by FernándezRamos et al., which inspired this post. See also this excellent paper by Gilson and Irikura.
The thermodynamic properties such as enthalpy, entropy, and free energy you get from a vibrational analysis by programs such as GAMESS and Gaussian are those of an ideal gas at 1 bar pressure (and usually 298 K). If you calculate free energy changes in solution (using methods such as PCM or COSMO) there are a few things you should do differently compared to gas phase calculations. These things will only make a difference if you are computing free energy changes for processes where the number of particles change, such as binding free energies. The corrections will cancel out for things such as conformational free energy differences.
Use Helmholtz free energies instead of Gibbs free energies
Experimental studies typically report Gibbs free energy changes ($\Delta G^\circ$), which are related to Helmholtz free energy changes ($\Delta A^\circ$) by$$\Delta G^\circ = \Delta A^\circ + p^\circ \Delta V$$ $\Delta V$ is the change in volume of the solution due to the reaction. This volume change is negligible so $\Delta G^\circ = \Delta A^\circ$ is a good approximation.
The Gibbs free energy printed by quantum chemistry program correspond to an ideal gas where $pV=RT$ and the difference between $\Delta G^\circ$ and $\Delta A^\circ$ is much larger.
Computing free energies with semiempirical methods
Most semiempirical methods such as AM1 and PM6 are parameterized such that the electronic energy matches experimental heat of formations ($\Delta H_f^\circ$) at 298 K. So a gas phase free energy change should be computed as$$\Delta G^\circ=\Delta\Delta H_f^\circT\Delta S^\circ$$i.e. you don't need any of the enthalpy information printed out as part of the vibrational analysis. A solution free energy change should be computed as $$\Delta A^\circ=\Delta\Delta U_fT\Delta S^\circ$$where $\Delta U_f=\Delta H_f^\circRT$
Added 2013.08.16: However, dispersion and/or hydrogen bond corrected semiempirical methods such as PM6DH+ are parameterized against electronic binding energies. So if you are computing binding free energies with such methods you need to add the translational, rotational, and vibrational enthalpy corrections to $\Delta\Delta H_f^\circ$.
Change the standard state to 1 mol per liter
The translational entropy printed out depends on the volume of the system, which is computed as $V=RT/p$ = 24.79 liters. For solution that volume should be 1 liter. Most programs do not allow you to change volume so you must apply the correction to the entropy$$S_{soln}^\circ=S_{gas}^\circ+R\ln\left(\frac{1}{24.79}\right)$$ yourself
Is it OK to use the rigid rotorharmonic oscillator approximation in solution?
Short answer: yes. The derivations of the translational, rotational, and vibrational free energies are done for an isolated molecule in vacuum, while a molecule in solution interacts with solvent molecules. However, a molecule in solution still has the exact same degrees of freedom as in the gas phase: it is free to explore the entire three dimensional volume and is free to adapt any rotational angle just like in the gas phase, so the resulting free energy expressions are the same. Similarly, the individual molecules still have $3N6$ internal vibrational frequencies. The energy from the solutesolvent vibrations are included in the solvation free energy.
CCH is an overlay journal that identifies the most important papers in computational and theoretical chemistry published in the last 12 years. CCH is not affiliated with any publisher: it is a free resource run by scientists for scientists. You can read more about it here.
Table of content for this issue features contributions from CCH editors Steven Bachrach, Marcel Swart, Thomas Cundari, and Jan Jensen:
Hydrogen capture by boron: a crazy reaction path!

0000000286358390 A recent article reports, amongst other topics, a
computationally modelled reaction involving the capture of molecular
hydrogen using ...
The Parameter Uncertainty Inflation Fallacy

Pascal Pernot (2017)
Highlighted by Jonny Proppe
In a recent study on uncertainty quantification, Pernot(1) discussed the
effect of model inadequacy on pre...
Deciphering a solar array surprise with Energy3D

Fig. 1: An Energy3D model of the SAS solar farm
Fig. 2: Daily production data (Credit: Xan Gregg)SAS, a software company
based in Cary, NC, is powered by a...
Triplet cyclobutadiene

Cyclobutadiene has long fascinated organic chemists. It is the 4e analogue
of the 6e benzene molecule, yet it could hardly be more different. Despite
nearl...
Automatic generation of a set of molecules

Many quantum chemistry projects have reached a point where setup and
analysis consumes more human time than CPU time, e.g. it takes all day to
setup enoug...
My ACS talk on Kekulization and aromatic SMILES

Here are the slides for the talk I presented last week at the ACS meeting
in Washington. It describes my understanding of the Daylight toolkit as
deduced b...
New Input Generator Framework in Avogadro 2

Avogadro 1.x had quite a large number of input generators that came from
very humble beginnings. They were designed to be easy to write, and to give
a s...